Pressure Systems 9022 Manuel d'utilisateur télécharger pdf (Page 101)

Pressure Systems, Inc. NetScanner™ System (9016, 9021, & 9022) User’s Manual

ii dd

Description ‘q’ read

index

www.PressureSystems.com

3 - 71

Enable Automatic Shifting of Calibration Valve during

Calculate and Set Offsets (‘h’) command (default). (9016

only)

Disable Automatic Shifting of Calibration Valve in ‘h’.

User will manually control calibration value. (9016 only)

0C 00

Set Cal Valves to RUN or LEAK Position (default)

— choice made by ii=12. (9016 only)

Set Cal Valves to CAL/RE-ZERO or PURGE Position

— choice made by ii=12. (9016 only)

see

chart

below

0D-0E -- Reserved for factory use

0F 00

Disable periodic Thermal Coefficient Update task.

Enable periodic Thermal Coefficient Update task

(default).

10 01-20

Set Number of A/D Samples to Average. (default = 8).

Valid values are 1, 2, 4, 8,10, 20 hex: (1, 2, 4, 8,16, 32

decimal)

11 -- Reserved for factory use

12 00

Set Cal Valves to RUN or CAL/RE-ZERO Position

(default) — choice made by ii=0C. (9016 only)

Set Cal Valves to PURGE or LEAK Position — choice

made by ii=0C. (9016 only)

see

chart

below

13 00

Use Static IP Address Resolution (default)

Use Dynamic IP Address Resolution (RARP/BOOTP)

(Results in immediately becoming the module’s new

power-on default)

14 00

Disable Host Response/Stream Back-Off Delay (default).

Enable Host Response/Stream Back-Off Delay as low-

order byte of Ethernet Address(converted to decimal value

* 20 µsec.).

Enable Host Response/Stream Back-Off Delay specified

per eeee as decimal value (* 20 µsec.)

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 193 194

Commentaires sur ces manuels

Pas de commentaire

Pressure Systems 9022 Manuel d'utilisateur Page 101

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Pressure Systems 9022